Videos
|
|
Checking Your Model In Hydromax
How to check your model in Hydromax before starting stability analysis. play
|
|
|
Concepts and Specified Condition
Explanation of basic concepts in Hydromax and demonstration of the Specified Condition analysis. play
|
|
|
Upright Hydrostatics
The Upright Hydrostatics analysis mode in Hydromax allows you to calculate hydrostatic properties at a range of drafts. This video explains setup and use of this analysis. play
|
|
|
KN Analysis
KN Analysis allows you to calculate cross curves of stability. This computes KN at a range of heel angles and displacements. This video shows how to set up and run KN Analysis and review results in table and graph form. play
|
|
|
Tanks And Compartments
Hydromax has an integrated editor for defining tanks and compartments. This video shows how to define tanks and compartments and edit their properties. play
|
|
|
Load Cases
This is a brief introduction to defining load cases in Hydromax. It covers adding loads, creating load groups, adjusting free surface moments in tanks and viewing loads. play
|
|
|
Equilibrium Analysis
The equilibrium analysis mode allows you to determine the hydrostatic properties of a vessel subject to a defined load case. play
|
|
|
Large Angle Stability
This video explains how to carry out large angle stability analysis in Hydromax. It also covers selecting stability criteria and reviewing results including the Gz curve. play
|
|
